Product Name: laminated rubber bearing brands: Kang Bridge Color: Black Product Specifications: Material: natural rubber OR neoprene thickness index: can be customized according to customer specifications: General + can be customized temperature: -40-60 degrees under pressure: more than 50 tons or more manufacturers Spot direct supply, can be used repeatedly, and low cost. This information is in no standard price, the specific price, please contact customer service! ! ! Thank you for your cooperation! ⑴, tetrafluoroethylene circular rubber bearing activities and how to check the activities of the points, much to put down steel bearing activities should be based on actual needs can make a square or round, steel bearing down on the buckle at 5mm depth groove to place the seat. ⑵, one-way bearing activities along the bridge to the displacement of the movable bearing and multi same amount of transverse displacement along the bridge, one of the great amount of displacement, so when the transverse displacement volume is not, you can choose a single to the active support. Installation methods and ordinary PTFE slide bearing plate bearing basically the same, but it should note the following: ⑴, tetrafluoroethylene plate bearing system used for bearing activities should be supporting the use of the same general plate bearing. ⑵, installation tetrafluoroethylene bearings must be carefully detailed, accurate center bearing support according to the design in place. Beam bottom plate and the support pad stone (or plate) parallel to the top surface and smooth as possible. All the same seat on the lower dense paste; with each piece bearing beams should be placed on the same plane, avoid bearing eccentric compression, uneven support and individual void phenomenon. ⑶, tetrafluoroethylene bearing installation if a problem needs to be adjusted, it can be from the top end of the beam between the underside of the support pad holder tetrafluoroethylene stone (or plate) coated with epoxy mortar shop to adjust. ⑷, when the beam has a longitudinal slope can be processed into a steel wedge slope corresponding to adjust, so that the contact surface of the stainless steel plate with tetrafluoroethylene seat remains level. ⑸, bearing oil groove pit tetrafluoroethylene face, full of sharp brushing will not play "295-3 Grease" is installed as a lubricant to reduce friction. ⑹, stainless steel surface in contact with PTFE plate does not allow damage, nap phenomenon; so as not to increase the friction coefficient and the damage to the PTFE sheet. ⑺, when off beam, in order to prevent the occurrence of longitudinal and transverse beams and seat slip, to use the wooden pad to be positioned on both sides of the triangular beam, the beam to be off the job after the completion of the removal of all. ⑻, in order to prevent the beam (upper structure) of lateral movement, or the upper sides of the bearing structure need to set up anti-slip stopper. ⑼, bearings and stainless steel plate position depending on the installation temperature may be, if there is sufficient length of stainless steel plates, stainless steel plates, any season, according to the center placement.